3/20/2015
12-1:30pm
Today I worked on the pelican more, and I need to find a command that will fill the hole in the face. I’ve sealed off just about every other open edge, but the mouth is still a challenge.
Also, the original model of the computer mouse crashed so I redid it and am still trying to use tsplines and other commands to make it into one complete solid
4:50-6:20pm
I moved all of my rhino 3d files from the year into the project folder. I also tried the check & repair mesh commands on the computer mouse but when i tried “fillmeshholes” the most it would fill was to this point
so I couldn’t get the boolean difference to go through
but I’m going to try to trim the whole piece higher up then extrude it so it has a flattened bottom